SatisGeo KAPPAMETER KM-7, Руководство по эксплуатации, Страница: 8 / 30

7
The second item in main menu is a link to the Memory menu, see chapter 2.6.4.
The third item is a link to the Setup menu, see chapter 2.6.5.
2.6.3 Measuring
The first item is Measure . On the right side of this item, an actually selected
measurement sensor is indicated (FLAT, PIN, CORE) . This can be changed in the Setup
menu.
If Enter button is pressed when Measure selected, the user is requested to set one of
three modes of measurement:
1. Single – one measurement.
2. Scan – data are continually measured and results are displayed on the display only.
3. Scan remote – continual measurement, where the measured data are transferred to
the PC via USB or Bluetooth and processed by the program KMdata.
After the mode of measurement is set, the initial measurement can be done (at least
30cm distance from a sample or other materials). This is indicated on the display by
“AIR1”
notice. In the case the Escape button is pressed, the main menu is displayed. If button Enter is
pressed, the initial measurement is taken and
“SAMPLE”
is displayed to indicate that the
initial measurement is done, and the KM-7 can be put to the sample to measure its
susceptibility. In the case the
Escape button is pressed, the
“AIR1”
notice is displayed again.
The selected sensor is indicated at the bottom line.
SAMPLE
Sensor: PIN
Figure 2-9 Ready for measuring
If the
“SAMPLE”
indicator is displayed and Enter button is pressed, the susceptibility
of the sample is measured. During the time of collecting signal, which takes ca 0.5s, the icon
M
is displayed at the left upper corner of the display and the beep is heard. Please do not
move the instrument when the
M
is on. To complete the measurement, the third step is
required, again the measurement at least 30cm far from solid materials, see the notice
“AIR2”.
The timeout between the steps is 10s. If the measurement is not completed by the
time, the notice
“AIR1”
is displayed and the kappameter is ready to start anew. If the set of
the three measurements are completed properly, the value of susceptibility is displayed, see
Figure 2-10.
Mem indicator (left side) specifies location in the Memory menu, Loc indicator
(middle bottom) shows the user predefined location number. This can be set in the Memory
menu. Now, if the Enter button is pressed, the measured value is stored to the KM-7 memory,
if the Escape button is pressed, the measurement is lost. A new measurement can be taken.
0.239
E-3 SI
Mem:008 Loc: 10 PIN
Figure 2-10 Results