8
2.6.4 Memory menu
The
Memory
menu, see Figure 2-11, integrates all action linked to the nonvolatile data
memory, like browsing the stored data and erasing the memory. The location of measurement
can be set.
LIST
ERASE
LOCATION 10
Mem. free 965
Figure 2-11
Memory
menu
The first item
List
allows to view a stored data. If this item is selected and
Enter
button
is pressed, the most recently stored reading can be seen, see Figure 2-10. The measured value
is displayed in the center. Position in memory indicated by
Mem
, user defined location by
Loc
and used sensor are displayed at the bottom line.
If the data was measured with GPS enabled, indicated by left arrow in the bottom left
corner in display, then GPS coordinates can be displayed by pressing
Enter
button
,
see Figure
2-12. To go back to the data view,
Enter
button must be pressed again.
Lat:
49°14´31.07´´N
Long: 16°34´42.79´´E
Alt: 315.5m
Figure 2-12 Memory list, GPS coordinates
To walk through stored items,
Up
and
Down
buttons are used. The
Down
button goes to
older data,
Up
button goes to newer data.
If
Up
or
Down
button is pressed for a few seconds,
the move is faster.
Escape
button returns the control to the
Memory
menu.
The second item is
Erase
. All data stored in the KM-7 nonvolatile memory can be
deleted. Confirmation of this operation is required, otherwise this action is canceled.
The third item allows to set a measurement location, as described in chapter 2.4.
The last line shows free memory (number of readings without GPS data). Readings with
GPS coordinates are two times longer.
2.6.5 Setup menu
Various features of the KM-7 and measurement can be set up, see next chapters.
SENSOR PIN
SYSTEM
BT OFF
Figure 2-13
Setup
menu