User Manual
London – United Kingdom
www.saten.co.uk
UAE – Dubai
Fourth Floor, 30-31 Furnival Street
JAFZA - Al Aweer
Post code: EC4A 1JQ
TEL: +97143205447
TEL: +448456769185
FAX: +97143205448
Configuring NTP Server Settings
A Network Time Protocol (NTP) Server may also be set up on your DVR to maintain accurate current
date and time.
To set up an NTP server:
1.
Click Menu > Settings > Network to enter the Network Settings menu.
2.
Select the
Advanced
tab.
3.
Click the
Set
button next to
NTP
to enter the NTP Settings menu, as shown in Figure 8.
Figure 8. NTP Settings Menu
4.
Check the
NTP
checkbox to enable this feature.
5.
Configure NTP settings:
•
Synchronize Interval:
Time in minutes to synchronize with NTP server.
•
NTP Server:
Address of NTP server.
Note:
The address can be set to
the IP address or the
Domain name. When the Domain name is used,
please set the DNS server address.
6.
Click
OK
to save settings and exit the NTP Settings menu.
Note:
Time synchronization interval has a range of 0-10080 min, normally 7200 min. If the DVR is used
on a public network, you should use a NTP server that has a time synchronization function, such as the
server at the National Time Center (IP Address: 210.72.145.44). If the DVR is setup in a more
customized network, NTP software can be used to establish a NTP server used for time synchronization.
Configuring Remote Alarm Host Settings
With a remote alarm host set, the DVR will send a signal to the host when an alarm is triggered. The
