SATEL VIVER
3
DTR – module ready to send data to modem.
7 –
PHONE (RJ-11) socket for connecting telephone set (telephone line output).
8 –
LINE (RJ-11) socket for connecting analog telephone line (telephone line input).
9 –
VA...VD – sockets for connecting cameras A, B, C, D. The module only works with
the PAL recording system cameras.
Description of terminals:
+12V
–
power supply input,
COM
– common
ground,
DTA
– not
used,
CLK
– not
used,
INA...IND – triggering inputs (NO type) for sending sequences of images from the A, B,
C, D cameras to the monitoring station,
INE...INH – unlocking inputs (NO type), enabling images from the corresponding
cameras to be viewed (INE – camera A, INF – camera B, etc.).
1
2
5
RXD
COM
DTR
4
2
5
TXD
COM
DSR
3
RXD
TXD
3
4
8
RTS
CTS
Figure 2. Method of connecting the module to computer. PIN-5 module onboard connector is
shown on the left. DB-9 female connector is shown on the right (seen from the solder side).
4. Installation
Disconnect power supply before making any electrical connections.
The VIVER module is designed for indoor installation, in spaces with normal humidity of air.
Depending on the transmission channel (Ethernet, modem), connect the Ethernet cable
(to the RJ-45 socket) and/or the analog telephone line (to the LINE socket). Connect
the cables of the control device (detector or suitably programmed control panel outputs) to
the INA...IND inputs. Connect the cameras with which the module is to interface to the VA,
VB, VC, VD inputs. Then, connect power supply to the module.