SATEL
RX-2K • RX-4K
7
5.3 Deleting a keyfob
You can only delete individual keyfobs by using the DLOAD10 program.
1. Click “Read transmitter” to read the data of keyfobs enrolled in the controller.
2. Click on the keyfob you want to delete.
3. Click “Delete transmitter”. The “Confirm” window will be displayed.
4. Click “OK”. The "Confirm" window will be displayed.
5. Click “Write transmitters” to write the changes to the controller.
5.4 Restoring factory default settings and deleting keyfobs
When restoring the factory default settings, you can delete all keyfobs.
1. Press and hold down the PRG1 button.
2. After about 3 seconds, when the LED flashes red once, release the button.
3. Press and hold down again the PRG1 button.
4. After about 3 seconds, when the LED starts flashing red, release the button.
5. When the LED stops flashing red and turns on in green, it means that the factory default
settings of the controller have been restored.
5.5 Setting the operating mode for a relay output
You can set a different operating mode for each relay output. The output 1 pins are used as
an example in the table below.
Pulse mode
[jumper across two pins on the right] – the relay output is turned
on when the keyfob button is pressed (up to 30 seconds – then the keyfob
stops transmitting to prevent the battery discharge).
Monostable mode
[jumper across two pins on the left] – pressing the keyfob
button turns on the relay output for a preset time.
Bistable mode
[jumper removed from pins] – each pressing the keyfob button
changes the relay output status to the opposite one.
5.6 Programming the relay output cut-off time
If the relay output works in the monostable mode, you can program the cut-off time for it
ranging from 1 to 255 seconds (by default: 5 seconds). The cut-off time is programmed
individually for each output.
Programming the time by using buttons
1. Press twice the controller button designated with the number of the relay output for which
you want to program the time. The LED will go off.
2. Press the keyfob button. The LED will start flashing green and red alternately.
3. Measure the time during which the relay output is to be turned on and press the keyfob
button again. The LED will turn on in green.
Programming the time by using the DLOAD10 program
1. Click “Read times” to read the times programmed in the controller.
2. In the “Time” column, enter the cut-off time for the given relay output.
3. Click “Write times” to write the changes to the controller.
