SATEL
RX-2K • RX-4K
5
7. Press again and hold down the PRG2 [RX-2K] / PRG4 [RX-4K] button.
8. When the LED starts flashing (in a repeating “red – green – OFF” sequence), release the
button. The controller is ready to establish communication with the DLOAD10 program.
Note:
The controller is waiting 1 minute for communication with the DLOAD10 program to be
established.
9. In the DLOAD10 program, click in turn “File”
“New device”
“Keyfobs receiver
RX/RE/RXH”. The controller configuration window will be displayed.
Fig. 3. DLOAD10 program: controller configuration window.
5.2 Enrolling a keyfob
Enrolling a keyfob by using a button
You can use any button to enroll a keyfob, but only using the PRG1 button allows the keyfob
user to control all channels (relay outputs). If another button is used, the keyfob will only be
able to control some channels. For example, if you use the PRG2 button, it will only control
the channels 2-4 [RX-4K] / channel 2 [RX-2K].
Table 2 shows the channels (relay outputs) that can be controlled by using each keyfob
buttons, depending on which controller button was used to enroll the keyfob. The button
numbers refer to the keyfobs P-2, P-4, T-1, T-2 and T-4, whereas the symbols – to the
MPT-300 keyfob.
