2 AOD-200
SATEL
Light intensity [lx]
Detection threshold
Turning on [P
ON
]
Turning off [P
OFF
]
1 5
10
2 10
20
3 30
50
4 40
70
Table 1
Operating modes
The detector operating mode has an effect on operation of the motion sensors. Switching
between the operating modes is done remotely.
Active mode
– motion detection alarm or tamper alarm can be triggered. The microwave
sensor activates after motion is detected by the infrared sensor.
Passive mode
– tamper alarm only can be triggered. The microwave sensor is inactive.
During polling, the detector indicates whether motion has been detected by the infrared
sensor. The passive mode prolongs the battery life.
The alarm information is sent instantly.
Test mode
If you want to test the detector, you can remotely start the test mode. When in the test mode,
the detector LEDs are working. Time delay for the dusk sensor in test mode is 3 seconds.
LEDs
The LEDs are working for 2 minutes after inserting the battery, as well as in the test mode.
During detector startup, all LEDs are blinking alternately for about 40 seconds. The LEDs
indicate:
polling – a short flash of the red LED (80 milliseconds),
motion detection by the microwave sensor – the green LED is ON for 4 seconds,
motion detection by the PIR sensor – the yellow LED is ON for 4 seconds,
