SATEL AOCD-250
3
The used batteries must not be discarded, but should be disposed of in
accordance with the existing rules for environment protection.
Install the detector at the recommended height (Fig. 2-I).
Install the detector at a roofed location or under a protective roof, where streams of water
from rain or melting snow will not run down the enclosure.
Don’t install the detector closer than 3 meters from the moving objects (eg. tree branches,
bushes, laundry etc.) (Fig. 2-II).
Don’t direct the detector on reflective surfaces or on fans or a heat sources (Fig. 2-III).
Do not install the detector at any location directly exposed to sun rays.
1. Remove the front cover (Fig. 3).
2. Install the battery and add the detector to the wireless system (see the ABAX controller
manual or the INTEGRA 128-WRL / VERSA / VERSA Plus / VERSA IP control panel
installer manual). The sticker with serial number which shall be entered when registering
the detector in the system can be found on the electronics board.
3. Replace the cover.
4. Place the detector in the location intended for its installation.
5. Check the level of signal received from the detector by the ABAX controller or the
INTEGRA 128-WRL control panel. If the signal level is lower than 40%, select another
place for installation. Sometimes, it is sufficient to shift the device ten or twenty
centimeters to obtain a considerable improvement in the signal quality.
6. Remove the front cover (Fig. 3).
7. Push the fastening catches outward and remove the electronics board (Fig. 4).
8. Make the openings for screws.
To ensure tightness of the enclosure, make the holes only at places specially intended
for this purpose.
