SatelliteDish.com (954) 941-8883
Page 6 of 7
ATTACH THE FEEDHORN HEATERS TO THE FEEDHORNS
1. Each conductor coming from the Feedhorn Heater Cable connects to a splitter that branches into two female
leads. One female lead from each splitter should plug into each feedhorn heater.
2. Route the feedhorn heater cable along the feedhorn support arm.
3. Place each feedhorn heater around its feedhorn and loosely attach it by passing the tail of the strap through
the head. Be sure the heater wire in the feedhorn heater is against the feedhorn.
4. Position the heater with the head of the cable tie and the connectors toward the bottom of the feedhorn and
tighten the strap fully. Do not cut the tail off of the feedhorn heater at this time. It will be done when the final
test of the system is performed. See the Feedhorn Heater Placement picture for proper placement.
5. Use tie straps (not supplied) to anchor the Feedhorn Heater Cable near the feedhorn heater branch and
along its length.
Feedhorn Heater Placement
WIRE POWER TO THE CONTROL ENCLOSURE
1. The Anti-ice Control is supplied with a 50 foot 16 gauge 3 conductor power cable. The power cable can be
cut to length if needed.
2. Route the power cable to voltage source and connect the black and white wire to 240 volt single phase AC
power.
3. Connect the green conductor to a grounding source.
* There is no need to remove any covers on the Anti-ice Control enclosures.
* The entire system supplies 2125 watts of heat and draws approximately 8.9 amps.
SECURE ALL CABLES WITH TIE STRAPS
1. Secure the entire lengths of the heater pad cable, the feedhorn heater cable, and the power cable with tie
straps (not supplied).
