SatelliteDish.com (954) 941-8883
Page 5 of 7
2. Attach a sensor mounting bracket to the feedarm at the desired location. Self tapping screws or a u-bolt
may be used for attachment. The down leg of the bracket should be adjusted so that it points downward. See
the Sensor Attachment Drawing.
3. Adjust the Control bracket so that the moisture sensor on the top is level with the horizon. If needed, swivel
or bend the bracket on the feedarm to level the moisture sensor on top of the Anti-ice Control.
4. Tighten the
¼
-20 bolt and nut to secure the Control. Turn the Control the desired direction for viewing the
mode.
5. The cables exiting from the enclosure should exit in the downward direction. The final adjustment of the
control enclosure must be done before any cable ties are fully tightened.
Control Attachment Drawing
ROUTE THE HEATER PAD CABLE AND CONNECT TO THE HEATER PADS
1. Route the Heater Pad Cable toward the male heater pad leads for connection.
2. Choose a rib that will serve as the mounting location for the cordgrip on the Heater Pad Cable. The cordgrip
can be slid up or down the cable by loosening the plastic nut. Tighten the nut after adjusting.
3. Drill a 7/8” hole through the middle of the rib at the chosen position.
4. Remove the metal cordgrip locknut from the cable and pass the female leads and ground wire ring terminal
through the hole in the rib.
5. Pass the metal cordgrip locknut over the connectors and ring terminal, then thread it back on the cordgrip
and tighten.
6. Connect to the heater pads as illustrated in the Heater Pad Placement and Lead Connection drawing on
page 2.
7. Affix the grounding ring terminal to a grounded metal support structure.
8. Use tie straps (not supplied) to anchor the Heater Pad Cable.
