Edition du 25/02/09
/18
U508219-e Revision : 2
14
E. RIGHT-HAND WHEEL INCHING
MECHANISM ADJUSTMENT.
1. Adjustment of the inching of the printer's
right-hand wheel is accomplished by turning
the adjusting set screw, Figure 18. Turning
screw clockwise, the inching occurs at a higher
number and counterclockwise at lower inching
numbers.
2. With reference to the printer only, inching
should take place between 0.3 and O.4 above
any previous number
.
SECTION 6. REPAIR AND REPLACEMENT
A. TICKET TRAY REMOVAL
(Figure 19).
1. Turn knob to print position (print hammer
down) and remove printing arm spring.
2. Turn knob to stop position (seal lever up).
3. Flip printing arm to rear and remove three
groove pins from printing arm shaft.
4. Pull out printing shaft from left side.
5. Remove pin from printing arm cam and reset
drive gear.
6. Remove E-ring from center knob shaft. Pull
shaft out from right side until flush with frame.
Leave gears engaged.
7. Remove ail tray rod clips and tray support
rods.
8. Lift tray up while tilting left side up.
Figure 18. Right-hand Wheel Inching Mechanism
Adjustment
Screw
Figure 19. Ticket Tray Parts Identification
Inching Mechanism
Adjustment Screw
No-Back
Pawl
Printing
Arm
Printing
Shaft
Printing Arm
Cam Pin
Tray
Rod
E-Ring
Spacer
Rebound
Plate
Center
Knob
Shaft
Seal Pin
Actuating
Arm
