SATA SATAjet 4000 Series, Руководство по эксплуатации

Страница: 44 / 64

III.6
EN
Operating instructions SATAjet 4000-110/-120 (DIGITAL)
Warning! Risk of explosion!
The following applications and operations lead to the loss of
the explosion protection and are, therefore, prohibited:
• Battery replacement in explosive areas!
• Removal of the front cover of the pressure display!
• Installation of a battery other than the CR 1632 Renata!
When exchanging the battery, it is recommended to also replace the
sealing of the battery compartment!
7. Use
Warning! Risk of explosion!
• Use only solvent-resistant, antistatic, undamaged and technically flaw -
less compressed air hoses with a permanent pressure resistance of
minimum 10 bar, e.g. Art. No. 53090!
Notice!
The following requirements must be fulfilled:
• Use a compressed air connection G 1/4 a or a suitable SATA connec-
tion nipple.
• Ensure minimum compressed air volume (air consumption) and pres-
sure (recommended spray gun inlet pressure) according to chapter 2.
• Use clean compressed air, e.g. by installing the SATA filter 484, Art.
No. 92320
• Use an air hose with minimum 9 mm internal diameter (see warnings),
e.g. Art. No. 53090.
1. Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
tightened firmly. Tighten fluid tip [2-1] firmly by hand (14 Nm) accord -
ing to [7-4] . Check if locking screw [2-5] has been firmly tightened
according to [10-1] . Tighten, if necessary.
2. Rinse material passages with suitable cleaning solution [2-6] , ob-
serve chapter 8.
3. Adjust air cap: vertical spray fan
[2-7]
, horizontal spray fan
[2-8]
.
4. Insert paint strainer [2-9] and install gravity flow cup [2-10] .
EN-Content-BAL-SATAjet 4000 -110 -120.indd 6 29.10.2012 13:43:42