SATA SATAjet 3000 B RP, Руководство по эксплуатации

Страница: 407 / 426

Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP
407
US
Warning! Risk of explosion!
• Do not use solvents and cleaning agents based on halogenised
hydrocarbons! Chemical reaction which may occur when using these
substances may be explosive!
7. Use
Warning! Risk of explosion!
• Use only solvent-resistant, antistatic, undamaged and technically flaw -
less compressed air hoses with a permanent pressure resistance of
minimum 10 bar / 145 psi, e.g. Art. No. 53090 !
Information!
The following requirements must be fulfilled:
• Use of a compressed air connection G 1/4 male thread or of a fitting
SATA connection nipple.
• Ensure minimum compressed air volume (air consumption) and pres -
sure (recommended spray gun inlet pressure) according to chapter 2.
• Use clean compressed air, e.g. by installing the SATA filter 484, Art.
No. 92320
• Use an air hose with minimum 9 mm inner diameter (see warnings),
e.g. Art. No. 53090 .
1. Check if all screws [2-1], [2-2], [2-3], [2-4] and [2-5] have been
tightened firmly. Tighten fluid tip
[2-1]
firmly by hand (max. 12 Nm)
according to [7-4] . Check if locking screw [2-5] has been firmly tight -
ened according to [10-1] . Tighten, if necessary.
2. Rinse material passages with suitable cleaning solution [2-6] , ob-
serve chapter 8 .
3. Adjust air cap: vertical spray fan
[2-7]
, horizontal spray fan
[2-8]
.
4. Attach gravity cup [2-9] .
5. Fill gravity cup (max. 20 mm below upper edge), close with the lid [2-
10] and insert anti-drip device [2-11] .
6. Screw connection nipple [2-13] (not included in delivery) onto the air
inlet.