SATA SATAjet 3000 B RP, Руководство по эксплуатации

Страница: 411 / 426

Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP Operating Instructions SATAminijet 3000 B HVLP, minijet 3000 B T HVLP
411
US
Information!
Check sealing surfaces inside the spray gun [8-2] after disassembly,
clean them, if required. Should the sealing surfaces be damaged,
please contact your SATA dealer. Align new air distribution ring by
means of the marking [8-3] , (pin into drilling) and press in with even
force. Adjust material flow according to chapter 7.2 after installation.
9.3. Replacing the Paint Needle Sealing Steps:
[9-
1], [9-2] and [9-3]
When paint material leaks from the self-tensioning paint needle packing,
it needs to be replaced. Remove trigger according to [9.2] . After disas-
sembly, check if the paint needle is damaged or replace the nozzle set, if
required. Adjust material flow according to chapter 7.2 after installation.
9.4. Replacing the Air Piston, Air Piston Spring
and Air Micrometer Steps:
[10-1], [10-2] and [10-3]
Warning!
• Disconnect spray gun from the compressed air circuit!
When air leaks from the air cap or the air micrometer without the trigger
being pulled, these parts need to be replaced. After disassembly, grease
the air micrometer and spring with SATA high performance grease
(Art.
No. 48173) , insert them together with the air piston and thighten the
locking screw [10-1] . Adjust material flow according to chapter 7.2 after
installation.
Warning!
• Check if locking screw has been firmly tightened! Air micrometer could
shoot out from the spray gun uncontrolled!
9.5. Replacing the Sealing (air side)
Warning!
• Disconnect spray gun from the compressed air circuit!