SATA jet 3000 K HVLP, Руководство по эксплуатации

Страница: 392 / 404

392
US
Operating Instructions SATAjet 3000 K RP/HVLP
9.6. Replacing the Spindle of Round/Flat Spray
Control
Steps: [11-1], [11-2], [11-3], [11-4]
It needs to be replaced when air leaks from the control knob or when flat/
round control does not work. After disassembly, apply some sealant on
thread of the spindle, e.g. Loctite 242 [11-4] .
10. Troubleshooting
Malfunction Cause Corrective action
Fluttering/spitting
spray fan or air bub-
bles appearing in the
gravity flow cup
Fluid tip has not been
properly tightened
Tighten fluid tip
[2-1]
with universal
spanner
Air distribution ring is
damaged or clogged.
Replace air distribu-
tion ring, as it will be
damaged during disas-
sembly
Spray pattern is too
small, crooked, lop-sid-
ed or splitting
Clogged air cap drill-
ings
Clean air cap, observe
chapter 8
Damaged fluid tip (fluid
tip aperture)
Check if fluid tip is
damaged, replace the
nozzle set, if neces-
sary, chapter 9.1
No function of round/
flat spray control - con -
trol knob can still be
turned
Air distribution ring has
not been positioned in
correct location (pin is
not located in the drill-
ing) or damaged
Replace air distribution
ring making sure it has
been positioned cor-
rectly when inserting it,
chapter 9.2
Round/flat spray con -
trol cannot be regu-
lated
Control has been turned
too much in counter-
clockwise direction;
spindle has loosend
inside the spray gun
thread
Remove control with
single head spanner;
rectify or replace com-
pletely, chapter 9.6
Spray gun does not
shut-off air
Clogged air piston seat
or worn air piston
Clean air piston seat
and/or replace air pis-
ton, air piston packing,
chapter 9.4