SATA filter 434, Руководство по эксплуатации

Страница: 301 / 313

301
US
Operating instructions SATA filter 400 Operating instructions SATA filter 400
10. Maintenance
Danger! Notice!
• Filters can only be maintained and serviced when depressurized!
• Sintered filter [A]/Art. No. 22160 and filter housings [1-8], [1-12]
have to be cleaned after 6 months at the latest; replace sintered filter,
if necessary!
• The fine filter cartridge [B]/Art. No. 81810 has to be replaced every
6 months at the latest!
• The activated charcoal cartridge [C]/Art. No. 85373 has to be re-
placed every 3 months at the latest!
• When the compressed air is heavily contaminated, the filter
cartridges have to be exchanged in shorter intervals!
• Saturated filter cartridges may cause quality problems during paint
jobs. Furthermore, using a supplied-air respirator could become harm-
ful, causing permanent health damage and even death!
• Depressurize filter (close shut-off tap)
• Unscrew [3] the respective filter housing with the pin spanner included
in the delivery.
• Remove condensate cyclone separator [4-1] from the filter stage
[A] , remove and check insert as well as sintered filter [4-2] . Clean or
replace if necessary
• Remove [4-3] and replace fine or activated charcoal cartridge on filter
stages
[B]
and
[C]
• Installation has to be carried out in reverse order. Please make sure
that the filter cartridges are installed in the correct order. Coloured
markers (yellow = sintered filter
[A]
, blue = fine filter
[B]
, black = acti-
vated charcoal filter [C] allow clear identification [4-4] . Marking rings
are located on the threaded rods of the filter stages [B] and [C] .
• During installation, please ensure proper seat and undamaged O-rings!
Information!
Please observe local regulations for the disposal of filter cartridges!
6718-BAL-SATA filter 400.indb 301 24.04.2015 10:26:39