Sartorius TS 12, Инструкция по установке и эксплуатации

Страница: 7 / 40

7
Startup
Place the weighing platform
(5) on the scale.
Connecting the Scale to AC Power
The scale is energized by an external power supply.
Make sure that the voltage rating printed on this unit is
identical to your local voltage rating.
lf the voltage specified on the label or the plug design of
the power supply does not match the rating or Standard
you use, please contact your Sartorius Office or dealer.
Insert the right-angle plug of the power supply in the AC
jack as shown in the picture on the left. Tighten the screw
by hand.
The IP 65 protection rating is guaranteed only if a
rubber gasket is instalied and the plug is securely
connected to form a leak-tight seal.
Then plug the power supply into a wall outlet.
Important Note:
Only use original Sartorius Power Supplies identified by
the Sartorius label. Use of power supplies from other
manufacturers, even if these units have a registered
approval rating from a national testing laboratory, requires
the consent of a certified Sartorius service technician.