7
Connection to AC Power
The equipment is powered through the AC adapter provided.
Make sure that the voltage rating printed on the power
supply is identical to your local AC power rating. When
connecting the scale to the power supply, the laws valid
in your country must be observed. If you should have any
questions, please contact your supplier or Sartorius
Customer Service for information on the legal regulations
applicable in your country. Use only genuine Sartorius
power supplies. The use of power supplies from other
manufacturers, even if these units have a registered
approval rating from a national testing laboratory, requires
the approval of a certified technician.
§
Ground the scale.
Connect the cable to the grounding terminal (14).
§
Insert the right-angle plug into the IEC jack (13) on the
scale
Note:
When installing the scale in Zone 2 potentially explosive
atmospheres, connectors may only be plugged in or
disconnected when the power is switched off. You must
disconnect the scale from the power line before connect-
ing the AC adapter or peripheral devices (printer, PC) to the
data interface of the device.
§
Secure the right-angle plug in place with the safety
retainer provided. Operate the equipment only when this
plug is secured!
§
When connecting peripheral devices (printer, PC) to the
scale‘s data interface, make sure that the screws on the
data plug are securely tightened.
§
Plug the power supply into an electrical AC power
outlet
!
Observe the safety instructions and warnings in this manual
