Data cable connection only for PMA7501-X00GL
(Ethernet interface RJ45)
§
Plug the data cable of the EX link converter YCO11-Z
into the Ethernet interface port RJ45.
§
Check the switch position (16).
The switch must be set to the left position
(Ethernet interface).
Note:
The Ethernet interface has already been defined in
Setup, prior to delivery.
Data cable connection only for PMA7501-X00GL
(External RS-232 interface, D-Sub connector,
9-contact to YC011-Z)
If a data cable (D-Sub connector, 9-contact) is to
be connected to the EX link converter YCO11-Z,
the following measures are necessary:
§
Remove the protective cap and put it in a safe place.
§
Plug in the data cable and securely tighten the
screws.
§
The switch must be set to the right-hand position.
Important Note:
– An additional menu item must be configured in
Setup (refer to the chapter “Menu Settings”).
– If the data output port is not in use, please replace
the protective cap.
§
After connecting the data cable, plug it into the
socket.
Note:
!
You may only activate one data interface at a time.
9
