Sartorius CH3E, Руководство по эксплуатации

Страница: 50 / 96

Printing
There are several actions that generate
the command for outputting data to
the printer port:
– Pressing the
p
key. If the Setup
program is active, the menu settings
are printed (see “Configuring the
Combics”).
– Sending the SBI command “Esc k P _”.
For details, see “Data Input Format” in
this chapter.
– In some applications, pressing a given
key (e.g., to save a value or start a
routine) also generates a print
command. In this case, a configurable
printout
is generated with application-specific
data. For details, refer to the “Basic
Application Programs” manual for
the Combics 3. See also “Configuring
Printouts” below for sample printouts.
The
S
and
F
symbols are displayed
when data is being output to the
printer port.
Line Format
Each line of a printout can contain up
to 20 characters. The first 6 characters,
called the “data header”, identify the
subsequent value.
Configuring Printouts
To configure a printout, activate the
Setup menu and navigate to the menu
items shown in the diagram on the
left. For details on menu navigation,
see “Configuring the Combics”.
You can configure a different printout
for each interface. Each printout
contains your choice of the following
information blocks; to enable or disable
a block in the printout, select it or
deselect it in the Setup menu:
– Headers: Line 1, Line 2
– Date, time
– Dotted line and blank line (for the
Weighing application).
This block cannot be deselected.
It is printed to separate the next block
(“Initialization data”, below) from the
subsequent blocks.
– Initialization data (e.g., reference
sample quantity, reference piece
weight), followed by a blank line.
50
Device Parameters
Printout
Headers Line 1:
Line 2:
ID codes ID1:
ID2:
ID3:
ID4:
ISO/GMP o Off
printout For 1 application result
For several application results
Date/ o Date with time
time Date only
Once at o Off
stability
2
)
On
FlexPrint o Off
On
Printer 1 Number of o 1 printout
printouts 2 printouts
Result/ o Headers 1, 2
total o Date and time
printout
1
)
o Application ini data
o Scale ID
o Application result
o ID1, ... ID4
Components/ o Header line 1, 2
individual printout
1
)
o Date and time
o Scale ID
o Application result
o ID1, ... ID4
Printer 2 as for Printer 1
Factory Reset
settings
Do not reset
- Printout
o = factory setting
1
) = more than one can be selected
2
) = when the minimum load is exceeded (configure under:
Application parameters: ... : Minimum load for autotaring)