19
APPROVED
April 18
Configuration commands
The following sets of commands are used to configure each module and are usually carried out before
installing the module.
*A
n
Set rLine slave address (default: 1)
n=1-9
Example: *A2
Response: “ok” or “er1-4”
*B
n
Set RS232 baud rate (default 0)
n=0: 9600 bps
n=1: 19.2 kbps
n=2: 28.8 kbps
n=3: 38.4 kbps
n=4: 57.6 kbps
n=5: 115.2 kbps
Example: *B1
Response: “ok” or “er1-4”
NOTE! The new baud rate will become active after resetting the module.
*C
n
Enable LRC check for incoming messages (default 0)
n=0: LRC disabled
n=1: LRC enabled
Example: *C1
Response: “ok” or “er1-4”