Set up the Sterisart
®
universal pump
ergonomically in a suitable area
(cleanroom, laminar flow work
bench, isolator).
Before initial start-up, the acces-
sories supplied must be assembled
on the Sterisart Universal pump.
Please proceed in the following
order:
– At the back left, push the stand
(Fig.1, 7) onto the pin of the upper
part of the pump until it is firmly
in place. The holes in the foot of
the stand allow the positioning of
the stand to be altered.
– Fasten the holding ring for bottles
(Fig. 1, 8) and the fastening arm
(Fig. 1, 9) to the support rod.
If necessary, attach the ampoule
breaker (10) beforehand.
– Insert the bow (Fig. 1, 4) and the
clamping lever (Fig. 1, 3) on the
corresponding bolts on the top of
the pump. The lever is jacketed
in a plastic sleeve, which can be
removed for cleaning. If signs of
wear appear on this sleeve after it
has been in use for some time, it
can be re-ordered as a spare part
(see chapter “Ordering information
for the Sterisart
®
Universal Pump”).
– After connecting the drain tubing
to the barb (Fig. 1, 12) of the con-
tainer for draining (Fig. 1, 11);
attach the container for draining to
the appropriate bolts on the right
handle (Fig. 1, 5). The container for
draining and the cover plate are
attached by moving the tilting lock.
– Fasten the end of the drain tubing
to the appropriate drain.
5
5.
Startup
Very Important Note
Always make sure that there is a
sufficient liquid level differential
(> 5 cm) between the container for
draining and the drain. This makes
safe drainage possible and prevents
backflow into the container for
draining. Make sure that the drain
tubing is kept lower than the pump
to prevent the drain pan from over-
flowing.
Treat the waste as a biohazard.
Only dispose of it in accordance
with current regulations.
– Plug the foot switch into the
designated socket located on the
rear panel. (see Fig 2, 3). Fasten the
plug to the socket by turning it
clockwise.
– Plug the power cable into the male
power socket on the back of the
Sterisart
®
Universal pump and into a
grounded electrical outlet (Fig. 2,
2).
– Use the On | Off switch (Fig. 2, 1)
at the rear side of the Sterisart
®
Universal pump to turn it on.