QuickSeal
®
Cutter
13
Operation
5.3 Cutting the Collar
t
Install the battery into the base of the QUICKSEAL
®
cutting tool. Be sure the
trigger is not depressed during battery installation.
t
The cutting head should be fully open. Push and hold the retract button until
cutting head is fully open.
t
Lay the metallic collar of QUICKSEAL
®
into the cutting head so that the
tubing | collar is resting on the tube guides.
− It is not necessary, and may result in malformed seal, to push the collar into
the pivot point between the upper and lower blades of the cutting head
− The guides present the collar to the cutting edge at a slight angle.
t
Pull the trigger and make the cut between the 2 arrows on the collar.
t
Hold the trigger down until the cutting tool achieves pressure relief which is
accompanied by an audible “pop”.
t
The cutting tool returns automatically after the audible “pop”. Use the retract
button, if necessary to return the cutting head to the fully open position.
t
Remove battery from cutting tool; clean and store properly.
The cutting process can be interrupted at any moment by releasing the trigger.
If it is necessary to retract the ram before a cutting cycle is completed,
push the retract button. Pushing the retract button will result in the complete
retraction of the ram.
Lay QUICKSEAL
®
Collar in the trough of the cutting guides.
Correct
Incorrect