8
7. Before proceeding with installation, the hole must be cleaned of
all concrete dust to ensure proper fastening. Use a wire brush, a
vacuum or compressed air to clean out the hole completely.
(Figure 7)
8. Next, insert the drop in anchor with the open side up. Drop the
anchor into the hole. Tap lightly to get the anchor flush with the
base material.
9. Now, take the setting tool and insert it into the anchor. Strike the
setting tool with the hammer until the lip of the anchor touches the
lip of the setting tool. This will ensure the anchor is properly set.
(Figure 8)
Figure 7
Figure 8
