1 Template
Instructions
<<Delete before
use>>
EC
60
0
EC600 Power Control System
Issue 2.3
Page 15 of 20
10
th
August 2017
3.17 AL-KO ATC Operation
On caravans fitted with Al-Ko Automatic Traction Control, the Swift Command App can be used to
monitor the status of the ATC from within your tow vehicle. More information on this can be found
within the Swift Command App and the associated user guide.
3.18 Temperature Readings
The EC600 Temperature sensor measures the ‘core’ temperature of the vehicle, and provides a figure
for information only. The same sensor also measures humidity, providing a figure (also for information
only) from within that bed box or storage area.
It is hoped that the temperature information is a particularly useful figure, for instance when checking
on the vehicle remotely during cold weather.
For vehicles fitted with Alde or Truma heating systems, this sensor is not used to control the heating
temperature as it is measured above the door by the Alde or Truma room sensor. The readings on the
heating system may vary relative to the storage area temperature below the bed.
For vehicles fitted with a Whale heating system, the sensor is used to control the heating temperature
as this system does not have its own sensor.
Heat from other items in the vehicle (in particular components from the heating system itself) will have
a bearing on the reading displayed by the Swift Command system. Ventilation is also present in the
majority of bed / storage areas, and air entering or passing through this area will also have an effect on
the temperatures and humidity levels displayed.
3.19 Bluetooth Pairing
Using the control panel, access the System Settings menu and then scroll to the Bluetooth pairing
section. Press the select button to start pairing, the power button LED will flash to indicate the pairing
mode. You can now pair your device to the system following the devices instructions to add a
Bluetooth item. Pairing remains on for 1 minute and is then turned off automatically.
Note: Further help with Bluetooth pairing is available in the form of a help video which can be viewed
on the Sargent website in the Support Information section.
3.20 System Warnings
The system incorporates a number of warnings that are active at specific times. These are
summarised below, and also covered by relevant sections of this manual.
When a warning is active a triangle will be displayed in the control panel header area.
Warning
When
Type
Fresh water level low
With pump turned on and fresh water
level low (less than 25% full)
Only available when an on-board tank
is fitted
Message on screen and 30 second
audible beep
Waste water level full
With pump turned on and waste water
level full.
Only available when an on-board tank
is fitted
Message on screen and 30 second
audible beep
Leisure battery voltage
low
With control panel power on and leisure
battery selected (as active battery) and
the voltage level falls below 10V
Message on screen and 30 second
audible beep.
With control panel power on and leisure
battery selected (as active battery) and
the voltage level is below 9V
Message on screen and 30 second
audible beep. If no action taken after
30 seconds then the system will
switch the power off to prevent severe
discharge of the battery
Note: This is an emergency cut off level to protect the battery from severe
