5
PAGE
INSTRUCTIONS FOR INSTALLING PARALLEL ARM APPLICATION
CLOSER MOUNTED ON
STOP SIDE OF DOOR
ACCESSORIES INFORMATION
CLOSER IS MOUNTED ON PLATE WHEN
TOP RAIL IS TOO NARROW
1430-D DROP BRACKET
2 1/2" MIN.
D
D1) Install main arm on the closer with the index mark on
spindle aligned with the number on the arm
Note: Left Hand Doors -align index mark with the # 4
on the main arm (as shown).
Note: Right Hand Doors -align index mark with the # 5
on the main arm (as shown).
D2) This requires the spindle to be rotated
D3) Rotate the spindle on the bottom of the closer to align
index mark with the required number on the arm
E1) Opening the door slightly, slide rod into swivel arm and
then close the door
E2) With the door in the closed position, swivel the arm so that
the pivot is 1-1/2" off the door surface (as shown below)
E3) Tighten the arm screw securely
INDEX MARK
ON SPINDLE
INDEX MARK
ON SPINDLE
1
5
2
3
MAIN
ARM
45
°
45
°
1
4
MAIN
ARM
3
E
Adjust closer
as required (See page 8 for details)
F
4
2
5
Left Hand Door
Right Hand Door
C
NUT FACES DOWN
NUT FACES UP
RIGHT HAND
DOOR SHOWN
LEFT HAND
DOOR SHOWN
LEFT HAND DOOR
PRELOAD 45
°
ARM
SCREW
ROD
FOOT BRACKET
HOLD
OPEN ARM
1430-J COVER PLATE
May be used when closer is mounted on
a narrow rail to improve appearance when
closer is viewed through glass
#8 MORTISE FOOT
For use where the
standard surface applied
foot cannot be attached
to the top casing or where
appearance is a major
factor
#H8 MORTISE FOOT
MORTISE NUTS FOR BOLTING THRU THE DOOR
ARE FURNISHED WHEN ORDERED
LEFT HAND DOOR
PRELOAD 45
°
ARM
SCREW
ROD
FOOT BRACKET
HOLD
OPEN ARM
1-1/2"
Attach hold open foot to frame with adjusting nut facing down for left hand door or up for right hand door, as illustrated below.
© SARGENT Manufacturing Company 2006, 2007 All rights reserved
FOR ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
A7140E
