2009 Sargent & Greenleaf, Inc.
Document 630-809
Revised 2/15/2010
Sargent & Greenleaf, Inc.
Sargent & Greenleaf S.A.
A Wholly Owned Subsidiary of Stanley Security Solutions, Inc.
9, chemin du Croset
PO Box 930, Nicholasville, KY 40356
1024 Ecublens, Switzerland
Phone: (800)-826-7652 Fax: (800)-634-4843
Phone: +41-21 694 34 00
Phone: (859)-885-9411 Fax: (859)-887-2057
Fax: +41-21 694 34 09
13. To install the battery, pull the keypad tab
out slightly and turn the keypad ring
counterclockwise. The ring will pull out from the
base far enough to reveal the battery
connector. Attach the battery and place it in the
battery compartment.
14. Push the keypad ring back against the base
and turn it clockwise until it clicks into place.
Test the lock function at least three times with
the door open before closing the safe.
2007 D•Drive Specifications
Attaching Screws:
Use only the screws provided with the lock. They must engage the mounting plate by at least four full threads. Do not use lock washers or thread
sealing compounds.
Recommended Attaching Screw Torque:
30 to 40 inch-pounds (33,9 to 45,2 Nm) for the lock body. No more than 15 inch-pounds (1,695 Nm) for the keypad
base attaching screws.
Minimum Lock Cable (Spindle) Hole Diameter:
0.375 inch (9,5 mm)
Maximum Lock Cable (Spindle) Hole Diameter:
0.406 inch (10,3 mm)
Lock is Designed to Move:
2.5 lbs. (11,12 Newtons) continuous / 10 lbs. (44,48 Newtons) maximum
Lock Bolt Maximum Free Movement:
0.352 inch (8,95 mm) 0.109 inch (2,77 mm) remains outside the edge of the lock case when bolt is fully retracted.
Maximum Bolt End Pressure:
lock is designed to withstand at least 225 lbs. (1000 Newtons)
Maximum Bolt Side Pressure:
safe and container boltwork or locking cam designs must never apply more than 225 lbs. (1000 Newtons) of side pressure on the
lock bolt.
Mounting Environment:
The lock body is designed to be mounted inside a secure container. The container must be constructed to offer protection against physical
attack directed at the lock. The amount of protection is dependent on the desired level of security for the system as a whole. Lock protection may include barrier materials,
relock devices, thermal barriers, thermal relock components, or any combination of these. Relock device attaching screws must NOT be longer than the depth of the
tapped hole provided in the lock case.
A minimum distance of .150 inch (3,8 mm) is recommended between the end of the lock case and the closest approach of the safe’s blocking bar or cam plate (which is
normally blocked by the extended lock bolt). Maintaining this clearance will allow the lock to deliver optimum performance.
Code Restrictions:
Personal data that can be related to a code holder, such as a birth date, street number, or phone number, should not be used in creating a lock
code. Avoid codes that can be easily guessed
Note:
Every installation of this product must comply with these requirements and those in the product installation instructions to qualify for the manufacturer’s warranty
and to comply with EN1300 requirements.
ALL DIMENSIONS IN INCHES
