........
......
RS232
RS485
485B
485A
GND
TXD
RXD
GND
WD1
WD2
BEL+
BEL-
BEEP
GLED
RLED
INWD0
INWD1
GND
+12V
RX+
RX-
485B
485A
RX+
RX-
485B
485A
485B
485A
TC
P
/
IP
RJ-6
RJ-3
RJ-2
RJ-1
TCP/IP
Installation Guide
Q2i
Fingerprint Color Multimedia for
Time Attendance & Door Access Control System
Step 1
Determine the Location and Positioning
of the Installation
•
Avoid installing the terminals in locations that has contact with a
strong light source (e.g direct sunlight, spotlight, fluorescent light,
etc)
•
Avoid installing the terminals in locations prone to high moisture or
condensation levels in the air
•
The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting Terminals
A. MOUNT ON WALL
•
After measuring the height accordingly and make relevant marking
on the wall, drill the screws into the wall to secure the back plate.
•
Attach the terminal to the back plate and tighten the screws. Refer to
Appendix II for dimensions and measurements of installation.
B. FLEXI-KIT
FingerTec offers flexi-kit
for all its time attendance
models. Attach the termi-
nal on the flexi-kit for con-
venience.
Step 3
Wiring for Power Supply
There are two ways to connect to the power.
1. Use the power adapter provided in the package and insert the
power adapter to the port marked A in the diagram.
2. Use power cables (black and red) to connect to a linear power
supply with specifications of 12VDC 3A. (Marked B)
© 2015 Timetec Computing Sdn Bhd. All rights reserved.• 022015
4 feet / 1.2 meter
(recommended)
USB PORT
POWER PORT
TCP/IP PORT
POWER CABLE PORT (B)
RS232/RS485
Data Converter
1. RS485 Single Connection
2. RS485 Network Connection
Wiegand OUT
RS232
cable
3rd party controller
with 26 bits
wiegand input
DC12V 3A
Power Supply
* Use either power input
Door Lock connector.
Refer to Appendix I
3rd party
controller with
26 bit swiegand
output
Wiegand IN
RS232/RS485
Data Converter
