Sapphire Audio PURE CROSSFIRE II PC-I7RD400, Руководство пользователя

Страница: 24 / 56

"
PC-I7RD400 User’s Manual
MEMORY CONFIGURATIONS
Install DDR DIMMs
Please follow steps below to install DDR DIMMs.
1. Hold the DDR DIMM module by the edges and remove it from its antistatic
package.
2. Make sure the clips at either end of the DIMM socket are pushed away from
the socket.
3. Position the DDR DIMM module above the socket and align the notch in
the bottom edge of the module with the key in the socket.
4. Insert the bottom edge of the DDR DIMM module into the socket.
5. When the module is seated, press down on the top edge of the DDR
DIMM module until the retaining clips at the ends of the socket snap into
place.
Note: Please turn the system off before installing or removing any device,
otherwise system damage can occur.
Memory Configurations
Please refer to the following recommended memory configurations.
Mode / (DIMM Type) Case Sockets
DDR1 DDR2 DDR3 DDR4
Single-channel / 1* Populated ---- ---- ----
(DDR400/DDR333/DDR266) 2* ---- Populated ---- ----
3* ---- ---- Populated ----
4* ---- ---- ---- Populated
Dual-channel / 1# Populated ---- Populated ----
(DDR400/DDR333/DDR266) 2# ---- Populated ---- Populated
3# Populated Populated Populated Populated
Note: • In dual channel mode, always install an identical (the same type
and size) DDR DIMM pair in sockets.
• It is not recommended to use a three DIMM configuration.
• Memory channel speed is determined by slowest DIMM populated
in system.
Clip
Clip
DDR DIMM
DDR DIMM Socket
Notch