CONNECTIONS
Connections to a
TV
not
with a
SCARY terminal or AUDIO
terminals
You will need an RF converter and RF cable (both
supplied).
1
Unplug the aerial cable from your
TV
and reconnect it
to the
ANT IN
terminal on the RF converter.
2
Connect the RF cable to the
ANT OUT
terminal on the
RF converter and to the
ANT IN
terminal on your
TV.
3
Connect the RF converter to your camcorder.
4
Turn the TV on, and start playback on the camcorder.
5
Select an available channel on the TV, e.g. not used
for broadcasting.
With a small screwdriver turn the R F channel screw on
the RF converter until the picture and sound from the
camcorder are played back clearly on the
TV.
4
2
26
AVAILABLE ACCESSORIES SOLD
SEPARATELY
Video light
A
video light (sold separately) can be installed on the
accessory shoe.
Installing the video light
Slide the video light foot
(A)
into the accessory shoe, until
a click is heard and it is firmly locked into place.
To remove the video light, press and hold button ( B), then
pull the video light toward the front.
Using the video light
Set the
POWER
switch on the camcorder to
"CAMERA",
set the stand-by switch to
"STANDBY",
then press the
power switch (C) on the video light to turn it on and off.
�Note:
The video light cannot be used if the remote
control is connected to the camcorder.
WARNING:
When the video light is used, it will get very hot. Be careful
not to get burnt by touching the front glass or the light
cabinet when the video light is on or just after it has been
turned off.
If the video light bulb is burnt out, have it replaced by the
dealer where it was purchased.
ND filters
ND4 filters available on the market (size: 37 mm), give
good results, when recording on a beach or a ski slope if
the sun is very strong, so that the picture is not over
exposed. For more details, please consult the dealer
where the unit was purchased.
Auto pan/tilt head (VAH-30)
