2
1
Connect the cables from the ceiling.
Push the excess of connected cables into
the ceiling.
For details on the connections, see page 5.
2
Check that the spring (H) on the base
chassis looks as shown in the figure
below.
3
Mount the camera unit using the two
base screws (J).
4
Push the sliding plate (K) in the arrowed
direction until it clicks, then connect the
pin connector cables from the camera
unit base to the circuit board.
b
Set up the camera remotely (see page 7).
b
Check the settings screen or camera
angle on a portable monitor (see page 7).
1
Adjust the angle of view by moving the
lens unit manually.
Make the arrow
(AA)
beside the lens point
upwards (the video image will be upside
down if pointing downwards).
2
Shape the flat cable on the back of the
lens unit.
1
Hook the cable on the back of the clamp
as shown in the figure.
2
Pull the cable in the arrowed direction
until the sag is gone.
3
Fold over the excess cable until there is no
more sag and insert it into the holder slits.
3. Mount the camera unit
H
J
H
K
2
4
4. Adjust/Check the video image
from the camera
Adjusting the lens position
and shaping the flat cable
Vertical or horizontal smear (streak
noise) may appear if the camera faces
an extremely bright light source. If so,
change the lighting angle while checking
the quality of the image on the monitor.
180
°
330
°
90
°
AA
2
1
3
L5BH2_XE(INSTALLATION).book 2 ページ ２００６年６月３０日 金曜日 午後６時３４分
