1
Installing on the Ceiling
1
Loosen the four screws (A) using the
hexagonal wrench (large) and open the
dome cover.
2
Unplug all the pin connector cables from
the circuit board.
3
Lift and turn the camera unit in the
arrowed directions so that the two
screws (B) become visible.
4
Pull out the sliding plate (D) in the
arrowed direction while pushing the
spring (C) indicated with a blue sticker
in the arrowed direction.
The camera unit is released.
1
Attach the cushioning sheet (E) to the
back of the camera unit base (F), open a
cable hole in the cushioning sheet, and
pass the cables through the cable hole.
2
Position the arrow (
2
) on the inner side
of the camera unit base (F) in the
direction of the lens.
The arrow is located roughly in the center of
the panning range.
3
Set the camera unit base (F) on the
ceiling and secure it by tightening
suitable screws and washers (G)
through the screw holes (4 places).
•
Length:
35 mm or more
•
Diameter:
3.5 to 5.0 mm
•
Height of screw head:
5 mm or less
(washer included)
1. Remove the camera unit
1
2
3
4
C
D
A
A
B
A
A
2. Install the camera unit base
Make sure to tighten the screws properly.
Using screws of sizes other than
specified may cause the unit to fall.
E
F
G
G
3
2
1
L5BH2_XE(INSTALLATION).book 1 ページ ２００６年６月３０日 金曜日 午後６時３４分
