8
4
Peel off the release-coated paper of the
cover sheet and cover the back of the
camera completely with the sheet,
aligning the hole with the central shaft.
1
Aligning the ribs (C) and hook (D) on the
camera unit with the slot on the base
plate, push the camera unit until it
clicks.
2
Tighten the camera unit securely using
the supplied screw (E).
b
Set up the camera remotely (see page 11).
b
Check the settings screen or camera
angle on a portable monitor (see page 11).
See “7. Install the dome cover” under
“Installing on the Ceiling” (see page 6).
Plug the PoE hub into a power outlet.
5. Mount the camera unit to the base
plate
6. Adjust/Check the video image from
the camera
7. Install the dome cover
D
C
E
8. Power on
When Moving the Camera from
Wall to Ceiling
1
Remove the cover sheet, being careful not
to distort it.
2
Free the locks
(G)
on the base chassis.
3
Push the spring and release the camera.
4
Mount the camera by following the
opposite procedure from that indicated in
“
4. Change the camera position
” (see
page 7).
• Check that the flat cable is not
caught between the chassis.
• When removing the cover sheet, be
careful not to deform the sheet.
Deformation of the sheet (such as
large wrinkle or bend on the sheet)
may cause the sheet to contact
inside the dome cover when it is
re-attached, which may prevent
normal operation of the camera.
G
L5BQ2_XE(INSTALLATION).book 8 ページ ２００６年８月２８日 月曜日 午後４時１分
