73
Acknowledging Special Precautions and the FCC Notice
FCC Notice
The phone may cause TV or radio interference if used in close proximity to receiving equipment. The
FCC can require you to stop using the phone if such interference cannot be eliminated.
Vehicles using liquefied petroleum gas (such as propane or butane) must comply with the National
Fire Protection Standard (NFPA-58). For a copy of this standard, contact the National Fire
Protection Association, One Batterymarch Park, Quincy, MA02269, Attn: Publication Sales Division.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Cautions
Any changes or modifications to your phone not expressly approved in this document could void your
warranty for this equipment and void your authority to operate this equipment. Only use approved
batteries, antennas and chargers. The use of any unauthorized accessories may be dangerous and
voids the phone warranty if said accessories cause damage or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and can be broken. Avoid
dropping, hitting, bending or sitting on it.
Body-Worn Operation
To maintain compliance with FCC RF exposure requirements, Body-worn operations are restricted
to belt-clips, holsters or similar accessories that have no metallic component in the assembly and
that provide at least
2.5
cm separation between the device, including its antenna whether extended
or retracted, and the user’s body. Use of non-recommended accessories may violate FCC RF exposure
requirements.
For more information about RF exposure, please visit the FCC website at www.fcc.gov.
Specific Absorption Rate (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy absorbed in the head of a
user of a wireless handset. The SAR value of a phone is the result of an extensive testing, measuring
and calculation process. It does not represent how much RF the phone emits. All phone models are
tested at their highest value in strict laboratory settings. But when in operation, the SAR of a phone
can be substantially less that the level reported to the FCC. This is because of a variety of factors
including its proximity to a base station antenna, phone design and other factors. What is important
to remember is that each phone meets strict federal guidelines. Variations in SARs do not represent
Содержание SCP-7500
Страница 1: ...SCP 7500 Operating Guide Draft ...
