OI-332-09EG
9
TIMER ON button
:
The air conditioner starts at the set time.
TIMER OFF button
:
The air conditioner stops at the set time.
TIMER SET button
This button is used to set the time at which you wish the air conditioner
to go on or off.
MODE selector button
Use this button to select AUTO, HEAT, DRY or COOL mode.
:
When this setting is selected, the air conditioner calculates the
difference between the thermostat setting and the room
temperature and automatically switches to the “COOL” or
“HEAT” mode as appropriate.
:
The air conditioner makes the room warmer.
:
The air conditioner reduces the humidity in the room.
:
The air conditioner makes the room cooler.
FLAP button
Press this button either to select to set the airflow direction to one of the
six possible positions manually, or to select the sweep function, which
moves the flap up and down automatically.
:
The airflow direction can be set manually. (six positions)
:
The flap moves up and down automatically.
To switch to the sweep function (
) when in the manual (
) mode,
hold down the FLAP button.
FAN SPEED selector
:
The air conditioner automatically decides the fan speeds.
:
High fan speed
:
Medium fan speed
:
Low fan speed
1 HR. TIMER button
:
When you press this button, regardless of whether the unit is
operating or stopping, the unit operates for one hour and then
shuts down.
ACL button
Puts the remote control unit into pre-operation status. Always press this
button after replacing the batteries.
Address switch
• Change the address switch to prevent mixing of signals from remote
control units when two Sanyo air conditioners are installed next to each
other. Normally, the address switch is set to A. When switching the
address, the remote control must be changed, and the jumper cables on
the indoor unit board must be cut. For more information, please contact
the dealer where you made the purchase.
• Normally, the tabs on the remote control unit should not be bent.
A/C SENSOR button
When you press this button (use a small-tipped object such as a ballpoint
pen), the
mark will appear at the display. And the room temperature is
detected by the sensor which is built into the indoor unit and the air
conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space heater
or in direct sunlight, press the A/C SENSOR button to switch to the sensor
on the indoor unit.
•
Automatic switching between cooling and heating
This unit automatically switches between cooling operation and heating operation according to the
difference between the room temperature and the temperature setting.
The remote control unit sends the temperature signal to the air conditioner regularly at three
minute intervals. If the signal from the remote control unit stops for more than ten minutes
due to the loss of the remote control unit or other trouble, the air conditioner will switch to
the temperature sensor which is built into the indoor unit and control the room temperature.
In these cases, the temperature around the remote control unit may differ from the
temperature detected at the air conditioner’s position.
Remote Control Unit (continued)
button
(1-HOUR OFF TIMER)
(ALL CLEAR)
(AUTO)
(HEAT)
(DRY)
(COOL)
1
HR.
NOTE
NOTE
NOTE
K-181AHA P01~P10 (ENG)
10/16/00, 5:17 PM
9
