Sanyo PLV-Z2, Руководство по обслуживанию

Страница: 25 / 80

-25-
■
Electrical Adjustment
Normal Mode Service Mode
"MENU"
"INPUT"
"POWER
ON/OFF"
Adjustment item Adjustment deta value
Service Mode
"Point Up / Down"
137 10
Computer
"Point Left / Right"
Service Mode
137 10
Computer
■
SERVICE ADJUSTMENT MENU OPERATION
■
To enter service mode
To enter service mode press the "MENU" and "INPUT"
buttons on the projector simultaneously and hold for 2
seconds. As shown in a figure, a service mode display
appears on a screen.
■
Adjustment
Adjust service data using the following control buttons.
1. "POINT UP" ------- An item number increases.
2. "POINT DOWN" -- An item number decreases.
3. "POINT RIGHT" -- An adjustment value increases.
4. "POINT LEFT" ---- An adjustment value decreases.
■
To exit service mode
Press the "POWER on/off" button only once on the projec-
tor or remote control unit to quit the service mode.
IC1841 on the main board stores the data for the ser-
vice adjustments, and should not be replaced except
for the case of defective device.
If replaced, it should be performed the re-adjustments
following to the “Electrical Adjustments”.
The data of lamp replacement monitor timer is stored
in the IC1841.
Please note that the lamp replace counter is reset
when the memory IC (IC1841) is replaced.
(Lamp replace counter can not be set to the previous
value.)
●
Caution to memory IC replacement
When IC1841 is replaced with new one, the CPU
writes down the default data of the service adjust-
ments to the replaced IC, refer to the service adjust-
ment table. As these data are not the same data as
factory shipped data, it should be required to perform
the re-adjustments following to the “Electrical
Adjustments”.
Please note that in this case the lamp replace counter
will be reset.
●
Caution of Main Board replacement (in the case
IC1841 is not defective)
When the main board is replaced, IC1841 should be
replaced with the one on previous main board. After
replacement, it should be required to perform the re-
adjustments following to the “Electrical Adjustments”.
In this case, the lamp replace counter can be kept the
value as before.
■
MEMORY IC REPLACEMENT
POWER
WARNING
LAMP
REPLACE
MENU INPUT
SELECT
ON-OFF