Sanyo PLC-XU56, Руководство по обслуживанию

Страница: 22 / 116

-22-
[Adjustment Condition]
●
Input signal
Video signal .......................... 1.0Vp-p/75
Ω
terminated, 16 steps gray
scale (Composite video signal)
Computer signal .................... 0.7Vp-p/75
Ω
terminated, 16 steps gray
scale pattern
Component Video signal ...... 0.7Vp-p/75
Ω
terminated, 16 steps gray
scale (Component video signal with
480p, 575p, 720p or 1080i format)
●
Picture control mode .............. “STANDARD” mode unless otherwise
noted.
Note:
* Please refer to “Service Adjustment Menu Operation” for entering the service mode and adjusting the service
data.
White 100%
Black 100%
●
Circuit Adjustments
CAUTION: The each circuit has been made by the fine adjustment at factory. Do not attempt to adjust the follow-
ing adjustments except requiring the readjustments in servicing otherwise it may cause loss of per-
formance and product safety.
Electrical Adjustments
16 steps gray scale pattern
After replacing the Power Board readjust the Output
voltage adjustment as follows.
1. Connect a digital voltmeter to pins 1 (+) and 3 (-) of
K6D
.
2. Adjust the voltage by using
VR611
as following.
AC Input Reading
230V 380V ±2V
Caution:
Be sure to connect the lamp when taking this adjust-
ment.
Output Voltage adjustment
1. Set the lamp mode to "Normal" and then enter the
service mode.
2. Select group no. “
111
”, item no. “
5
” and set data value
to “
1
”.
3. Connect a digital voltmeter to test point “
TP12V1
” (+)
and chassis ground (-). Select item no. “
89
” and
change data value to adjust voltage to be
6.0
±0.1V.
4. Connect a digital voltmeter to test point “
TP12V2
”
(+) and chassis ground (-). Select item no. “
91
” and
change data value to adjust voltage to be
6.0
±0.1V.
5. Connect a digital voltmeter to test point “
TP12V1
” (+)
and chassis ground (-). Select item no. “
90
” and
change data value to adjust voltage to be
13.5
±0.1V.
6. Connect a digital voltmeter to test point “
TP12V2
” (+)
and chassis ground (-). Select item no. “
92
” and
change data value to adjust voltage to be
13.5
±0.1V.
7. Select item no. “
5
” and set data value to “
0
”.
z
Fan Control adjustment
* This adjustment is not required even if the power
board is replaced because this adjustment is carried
out before parts shipment.