Sanyo PLC-XU301, Руководство по обслуживанию

Страница: 10 / 112

-10-
Lamp Replacement
How to check Lamp Used Time
The LAMP REPLACE indicator will light yellow when
the total lamp used time (Corresponding value) reaches
,500 hours. This is to indicate that lamp replacement
is required.
The total lamp used time is calculated by using the be-
low expression,
Total lamp used time =
t
eco +
t
normal x 1.5
t
eco: used time in the Eco mode
t
normal : used time in the Normal mode.
You can check the lamp used time following to the be-
low procedure.
1
Press and hold the oN/StANd-BY button on the pro-
jector for more than 0 seconds.
2
The projector used time and lamp used time will be
displayed on the screen briefly as follows.
recommendation
Should the air filter become clogged with dust particles, it will reduce the cooling fan’s effectiveness and may re-
sult in internal heat build up and short lamp life. We recommend cleaning the air filter after the projection lamp is
replaced.
Refer to “Air Filter Cleaning”.
Counter
Projector
450H
Lamp
Normal 200H
Eco 250H
Corresponding value 500H
Total lamp used time
Projector used time
Counter
Projector
450H
Lamp
Normal
Eco
Corresponding value
Note:
When non-standard lamp is used, lamp used time
should not appear.
Warning Message on the non-standard lamp used
If the non-standard lamp is used, the warning and confirmation messages will appear on the screen every startup.
Some of the functions are limited when the non-standard lamp is used in spite of the warning.
Since the lamp is not standard,
projector failed to read lamp data.
Continue to use this lamp?
Yes
No