Sanyo PLC-XE33, Руководство по обслуживанию, Страница: 32 / 110

--
Electrical Adjustments
1. Enter the service mode.
. Receive the 16-step grey scale composite video sig-
nal with
Video
mode.
. To start the auto-calibration for Component adjust-
ment, select group no. “
260
”, item no. “
0
” and then
change data value from “
0
” to “
1
”. After the auto-cali-
bration completed, "OK" will appear on the screen.
6. Auto calibration adjustment [Video]
Gain adjustment [Video]
1. Enter the service mode.
. Receive the 16-step grey scale composite video signal
with
Video
mode.
. Connect an oscilloscope to test point “
tP35G
” (+)
and chassis ground (-).
4. Select group no. “
20
”, item no. “
0
” and adjust the
amplitude “
a
” to be minimum by changing the Data
value.
(a)
White Level
below adjustment is performed when the above auto
calibration is failed.
1. Enter the service mode.
. Receive the 50%-Whole Gray computer signal with
computer1 [rGB] mode.
. Select group no. “
100
”, item no. “
92
” and change
data value to “
2
” to reduce the panel frequency.
4. Project only green light component to the screen.
5. Select group no. “
101
”, item no. “
1
” and change
data value to obtain the minimum flicker on the
screen.
6. Project only red light component to the screen.
7. Select item no. “
0
” and change data value to obtain
the minimum flicker on the screen.
8. Project only blue light component to the screen.
9. Select item no. “
2
and change data value to obtain
the minimum flicker on the screen.
10. Select group no. “
100
”, item no. “
92
” and change
data value to “
0
” to reset the panel frequency.
7. common center adjustment
1. Enter the service mode.
. Receive the 16-step grey scale composite video sig-
nal with
Video
mode.
. Connect an oscilloscope to test point “
tP35G
” (+)
and chassis ground (-).
4. Select group no. “
100
”, item no. “
6
” and change data
value to adjust amplitude “
a
” to be
2.2V
.
(a)
white level
white level
10. 50% White adjustment [Video]
1. Enter the service mode,
. Receive the 16-step gray scale computer signal with
computer1 [rGB]
mode.
. Select group no. “
100
” item no. “
7
” (Red) or “
8
”
(Blue), and change Data values respectively to make
a proper white balance.
Confirm that the same white balance is obtained in vid-
eo and computer input.
9. White Balance adjustment [Pc]
1. Enter the service mode.
. Receive the 16-step grey scale computer signal with
computer1 [rGB]
mode.
. Connect an oscilloscope to test point “
tP35G
” (+)
and chassis ground (-).
4. Select group no. “
100
”, item no. “
6
” and change data
value to adjust amplitude “
a
” to be
2.2 V
.
(a)
white level
white level
8. 50% White adjustment [Pc]