-6-
Mechanical Disassemblies
2. Chassis Removal
[ATTENTION]
This PDP monitor is used the different kind of screw.
Using
correct screw
is needed to avoid the damage.
2-1 Fans Removal (Fig. 3)
FN1901
1) Remove screws (FN1: 3pcs) and take Fan (FN1901)
with the holder off.
2) Remove screws (FN2: 2pcs) and take Fan from the
holder.
FN1903
1) Remove screws (FN3: 2pcs) and take Fan (FN1903)
off.
2-2 Power Board Removal (Fig. 3)
1) Remove screws (P1: 5pcs) and take Power Board
off.
✽
Remove screw (P2: 1pc) and take Power Board with
the holder off.
2-3 Sensor-A Board Removal (Fig. 3)
1) Remove screw (SA1: 1pc) and take Sensor-A Board
off.
✽
Remove screw (SA2: 1pc) and take Sensor-A Board
with the plate off.
✽✽
Remove screw (STB1: 1pc) and take Speaker
Terminal Base (R) with the Sensor-A Board and
holder off.
2-4 Sensor-B Board Removal (Fig. 4)
1) Remove Sensor-B Board from the Hook.
✽
Remove screws (SB1: 2pcs) and take Sensor-B
Board with the plate off.
2-5 Jack-B Board Removal (Fig. 4)
1) Remove screw (B1: 4pcs) and take Jack-B Board
with the holder off.
✽
Remove screw (STB2: 1pc) and take Speaker
Terminal Base (R) with the Jack-B Board and holder
off.
2-6 Main and Jack-A Boards Removal (Fig. 4)
1) Remove screws (SP1: 6pcs) and take Shield Plate
(for Main and Jack-A board) off.
2) Remove screws (M1: 6pcs) and take Main board off.
3) Remove screws (TP1: 6pcs) and nut-screws of the
terminals on Jack-A board (6pcs), and take Terminal
Plate off.
4) Remove screws (A1: 2pcs) and take Jack-A board
off.
Note: If the cable is fixed by ferrite core or CV band
(fixer), remove it as the need arises. After servic-
ing, it is necessary to be fixed again to previous
position.
Power
Sensor-A
FN1901
FN1903
Speaker
Terminal
Base(R)
SA1
SA2
STB1
FN2
FN2
FN1
FN1
FN1
FN3
FN3
P2
P1
P1
Fig. 3
Fig. 4
Sensor-B
SB1
Hook
Speaker
Terminal
Base(L)
STB2
Jack-B
B1
B1
SB1
Jack-A
Main
Shield Plate
Terminal Plate
SP1
SP1
SP1
SP1
SP1
A1
M1
M1
M1
TP1
TP1
TP1