14
Fig.4-18
front door pl
latch switch hold
screw
Fig.4-21
wires (4 -17).
Assembling steps:
1.
Put the motor shaft into its connecting hole, and fix the motor
with two screws (FIG.4 - 17).
2.
Plug in the two wires.
3.
Assemble and fix the middle base board with two screws
(FIG.4 - 18).
4.
Turn the oven back.
5.
As the FIG.4 – 19 shown, fix in the turntable shaft supporter,
the place in the roller ring and the glass tray as FIG .4 – 20.
4
4
.
.
1
1
0
0
T
T
H
H
E
E
D
D
O
O
O
O
R
R
S
S
A
A
F
F
T
T
Y
Y
I
I
N
N
T
T
E
E
R
R
L
L
O
O
C
C
K
K
S
S
.
.
Firstly, do as the same with 1, 2, 3, steps of of this part.
Steps for dismantling:
(1) Pull out the terminal plugs of the interlock switch and the pilot switch.
(2) Loosen out the two screws which fixed the switch holder with a “+”- screwdriver, and take the switch holder
off.
(3) Take off the interlock switch and the pilot switch from the holder.
(4) Take off the switch connecting lever arm and the working lever from the holder.
Assembling steps:
(1) Slip on the connecting lever arm and the working lever into the switch holder.
(2) Assemble the interlock switch and pilot switch to the switch holder, make sure they are assembled correctly.
(3) Tightly fix the holder with two screws.
(4) Check the position of the hook and the switch holder.
Close the door, push and pull the low and up part of the
door to check whether the door is flexible. If it does, back
and front position of the holder should be adjusted.
Provided the up hook is loose, the door should be pushed
more closely to the oven, and pull the holder inside closely
after loosen the screw which fix the holder, then, tighten the
screw and check whether it is still loose. If it is not or the
loose is minor, it would be OK. Open the door, then close it
lightly, check whether the hook is in position, if not,
readjustment is needed. If the loose is at lower part of the
door, the adjust methods is the same with the above said
Fig.4-19
turntable shaft supporter
roller ring
