12
fan motor
power supply cord
Fig.4-11
lead
earthing screw
fuse housing
power supply cord
Fig.4-12
5.
Take off the right baseboard, the seat and the rubber space between the transformer and the oven.
to mount the transformer,
1.
Place the transformer as the FIG.4 - 9, tear off the protective paper of the rubber lining tape, stick it on the
transformer as shown on the figure. Then put on the seat and the right base board, make sure the screw
hole are tallied, then tighten the four screws for the high voltage winding is earthing here.
2.
Fix the transformer on the oven as FIG.4-10.tear off the protect paper of the rubber spacer, set it between the
transformer and the oven, make sure the adhesive side is sticked on the oven.
3.
Plug in all the terminals of the transformer precisely.
4
4
.
.
6
6
T
T
H
H
E
E
F
F
A
A
N
N
M
M
O
O
T
T
O
O
R
R
.
.
Firstly, do as the 1, 2, 3, steps of of this part.
To disassemble,
1.
Pull out the two terminal of the fan motor (FIG. 4 –11).
2.
According to the FIG.4 –12, pull out the lead plug which
marked “A” and “C” from the thermal cutout and the fuse
housing separately, and take off the earthing screw which
marked “B” (FIG.4 -12).
3.
Take out the power supply cord from the trough as the
figure shows.
4.
Loosen the screws shown on the FIG.4 –13 with a “+” –
screwdriver, and take off the fan holder.
5.
Take off the fan from the fan motor shaft as FIG.4 –14, then the fan motor.
to mount the fan motor,
1.
Assemble the fan motor as FIG.4 – 14. Drip the glue on
the “ ” place of the fan motor shaft, and fix the fan on the
motor, make sure it must be fixed to the bottom of the
shaft. Attention: The fan motor shaft should not be curved,
the fan should have no abnormal stick up. After
assembled, check whether the running fan would knock
the fan holder.
2.
Assemble the fan holder as FIG.4 – 13, Then connect the
power supply cord with the two wires of the fan motor, and
tighten the screws as FIG.4 – 11 and FIG.4 – 12.
transformer
base board
screw
seat
Fig.4-9
Fig.4-10
