Sanyo DVD-DX518, Инструкция по эксплуатации

Страница: 14 / 23

System Setup
1.6 LAST MEMORY
2 AUDIO SETUP PAGE
2.1 ANALOG AUDIO SETUP
2.1.1 DOWNMIX
LT/RT: The 5.1-channel audio is mixed into left channel and right channel and is output via
the FL and FR speaker respectively.
STEREO: The 5.1-channel audio is mixed into stereo signal and is output via the FL and FR
speaker.
3D SURROUND: This mode creates a virtual surround effect from stereo or multi-channel
audio contents.
5.1CH: Turn off the DOWNMIX mode. If the unit is connected to 5.1-channel amplifier, this
item should be selected.
NOTE: This function only applies to the Dolby AC -3 encoded 5.1-channel discs.
2.2. DIGITAL AUDIO SETUP
2.2.1 DIGITAL OUTPUT
SPDIF OFF: There will be no digital audio signal output. (Coaxial off)
SPDIF RAW: The digital audio signal output will be in its raw format.
SPDIF PCM: The digital audio signal output will be in PCM format.
SPDIF PCM
ON : During a playback or in the paused/stopped status each time you open the disc tray or
turn off the player, the unit will memorize the last playback time. Next time when you insert
the same disc and close the disc tray to load the disc, the unit will play from the memorized
point.
OFF : Disable the last memory function.
2.1.2 FRONT, CENTER, REAR SPEAKER and SUBWOOFER
Only when the DOWNMIX mode is turned off ( DOWNMIX is set to 5.1CH ) are the CENTER
SPEAKER and REAR SPEAKER activated. The FRONT SPEAKER can be set to LARGE or
SMALL . The CENTER SPEAKER , REAR SPEAKER can be set to LARGE , SMALL or OFF
and the SUBWOOFER can be set to ON or OFF .
NOTE:
If the speaker is set to LARGE , the output level will be higher than that of SMALL .
If the speaker is set to SMALL , the output level will be lower than that of LARGE .
If a speaker is set to OFF , no audio is outputted from it.
2.1.3 DIALOG
When DOWNMIX is set to LT/RT or STEREO , this item is available.
Adjust the value of this item to control the dialog volume.
NOTE: When playing 5.1CH disc, this item can be used to adjust the volume of the speakers.
2.1.4 D.R.C. (Dynamic Range Control)
You can set this item to AUTO , ON or OFF .
2.2.2 LPCM OUTPUT
When DIGITAL OUTPUT is set to , this item is available.
Select a sample rating for the digital audio output. There are two options, 48KHz and 96KHz.
NOTE: Some amplifiers don't support 96KHz sampling which will affect the coaxial output.
-13-