Sanyo Carrier 16LJ Series, Руководство по установке

Страница: 8 / 52

1.2 - safe installation
Equipment installation must be carried out by a qualified
installer, taking the appropriate safety measures.
Ensure that unauthorized people cannot enter the installation
site during installation.
1.3 - Delivery inspection
Upon delivery of the Carrier-Sanyo chiller to the job site, the
owner or his designated representative should carefully inspect
the chiller:
•
Ensure that the chiller is factory-charged with nitrogen gas
to a pressure of 20 kPa.
• Open SV7 and connect a pressure gauge to SV2. Open
V2, V3 and B-valve, and check the pressure at the
pressure gauge. If the pressure is 0 kPa, the chiller has a
leak. In this case, check the leaking point with pressurized
nitrogen gas at 50 kPa. Close the cap of SV2 and SV7
with sealant.
• Refer to paragraph 1.8.2 (Fig. 5), exhibit LA and
the
specification drawings
.
solution volume
16LJ Absorbent Refrigerant Alcohol Inhibitor
kg kg l l
11 430 60 0.78 0.25
12 430 60 0.78 0.25
13 560 100 1.02 0.33
14 620 90 1.12 0.36
21 750 110 1.36 0.44
22 810 120 1.48 0.48
23 980 150 1.78 0.57
24 1070 140 1.94 0.62
31 1230 190 2.24 0.72
32 1340 170 2.44 0.78
41 1560 250 2.84 0.91
42 1680 230 3.06 0.98
51 1950 260 3.54 1.13
52 2170 290 3.94 1.26
53 2420 310 4.40 1.40
Legend
Absorbent Libr 50 wt %
Inhibitor Li
2
Moo
4
20 wt % 300 ppm (total concentration)
Alcohol octyle alcohol CH
3
(CH
2
)
5
CH(oH)CH
3
• Check for physical damage to the chiller
- Main shell and piping
- Valves
- Control panel
- Wiring and connections
- Accessories
- Solution
• Check the shipping or packing slip sent with the chiller
and note all missing items.
• Check all boxes or crates shipped with the chiller for
missing items.
NOTES:
1. Isolation pads are not required for most installations.
2. Inform Carrier immediately if items are damaged or
missing.