Remote Control Transmitter
5
1.
Open the battery cover.
2.
Install two “
AA
”
1.5
volt batteries so that the “+” and “-” marks on the batteries match the “+” and
“ - ” marks inside the unit.
3.
Close the battery cover.
Note:
Replace the batteries when the TV set is showing the following symptoms:
Operation is unsteady or erratic, sometimes the TV set does not work with transmitter.
Discharged batteries may leak and damage the unit. The normal life of batteries should be from
nine to ten months.
-/- -
-/- -
P
P
BASS
SOUND
S. SYS
SURROUND
A
•
B
PICTURE
SWAP
CH SCAN
TIMER
JXPSC
TV / AV
MENU
CH
CH
Power ON/OFF
button
ALTERNATE
button
button
TIMER
button
MUTE
button
CHANNEL SCAN
button
SURROUND
button
PICTURE MODE
button
Programme UP
button
RECALL/COLOUR SYSTEM
button
MENU
button
TV / AV Selector
button
Programme Selector
button
SWAP
button
VOLUME -
button
STEREO/MONO
button
Programme DOWN
button
BASS EXPANDER
button
SOUND MODE
button
(This button is not used)
SOUND SYSTEM
button
DIGIT
button
Battery Installation of the Remote Control Transmitter
General Operation
Important !
Be sure to set the
Mains ON/OFF
switch to the off
position, if the power failure occurs while viewing.
To switch on or off the TV ;
Press the
Mains ON/OFF
button.
The power of the TV is turned on or off complete-
ly. If no picture appears but the Standby and
Power indicator illuminates, press the
POWER
ON/OFF
button of the remote control transmitter
as the TV set is in standby mode.
To set the TV to standby mode;
Press the
POWER ON/OFF
button.
During Standby mode the Standby and
Power indicator illuminates more brightly.
To turn on the TV from the standby mode, press
any of the following button.
●
POWER ON/OFF
button of the remote control
transmitter.
●
Programme UP/DOWN
of the remote control
transmitter or the TV set.
●
1
to
9
,
0
button on the remote control
transmitter.
Power ON/OFF
-/- -
-/- -
-/- -
-/- -
-/- -
-/- -
-/- -
INST. M_29_BA6V-A(Aus) 4/10/07 11:14 AM Page 5