Sanyo C0971, Техническое и сервисное руководство

Страница: 97 / 108

16
Hole i n wall
Be n t part
Narrow t u be
Wide t u be
Rear pa n el
Fig. 38
Drai n cap
Drai n ho s e
Fig. 39
I
Left-side tubing
(1) Lead the tubing and drain hose through the wall,
allowing sufficient length for connection. Then bend
the tubing using a tube bender to make the attach-
ment. (Fig. 38)
(2) Switch the drain hose and drain cap.
Switching drain hose and drain cap
(a) Locate the drain hose and the drain cap.
(Fig. 39)
(b) Remove the screws fastening the drain hose on
the right side, and pull out the drain hose to
remove it. (Fig. 39)
(c) Apply moderate force to pull off the drain cap
on the left side. (If you cannot pull it off by
hand, use a long-nose pliers.)
(d) Reattach the drain hose to the left side and the
drain cap to the right side. (Fig. 40a)
Drain hose
Slide the drain hose fully onto the drain pan outlet
until the drain hose edge is pushed into the insula-
tion. Check that the screw holes in the drain bracket
and the drain pan outlet are aligned and securely in
contact, then fasten them with the screw. (After
attaching the drain hose, check that it is attached
securely.) (Fig. 40c)
Drain cap
Use a Phillips screwdriver to push the drain cap in
firmly. (If it is difficult to push in, wet the cap with
water first.)
(3) Install the indoor unit on the rear panel.
(4) Connect the tubing and wiring led inside from out-
doors.
(5) After completing a leak test, bundle the tubing
together with armoring tape and store it inside the
tubing storage area at the back of the indoor unit
and hold it with clamps. (Figs. 40a and 41)
Fig. 40a
Fig. 40b Fig. 40c
Fig. 41
Refri g era n t t u bi ng
I n ter- un it wiri ng
Co n d u it
S crew
Drai n ho s e
Drai n pa n o u tlet
S crew hole
Drai n bracket
Drai n cap
Clamp
Drai n ho s e
Drai n ho s e
Drai n bracket
I nsu latio n
07-105 KS0971-1271 5/10/07 9:17 AM Page 16