Sanyo 164 081 00, Руководство по обслуживанию

Страница: 4 / 18

- 3 -
2. HEAD AZIMUTH ADJUSTMENT
(1) Load the test tape(VTT-703, etc., 10 kHz) for azimuth
adjustment.
(2) Press the PLAY button.
(3) Use a cross-tip screwdriver to turn the screw for azimuth
adjustment so that the left and right output are maximized.
(4) Press the STOP button.
(5) After completion of the adjustment, use thread lock(TB-1401B)
to secure the azimuth-adjustment screw.
4. MOTOR SPEED ADJUSTMENT
(1) Insert the test tape(TCC-119, etc., 3,000 Hz).
(2) Press the
PLAY button.
(3) Use a flat-tip screwdriver to turn the SVR(located inside the
rear of the motor) to adjust SVR so that the frequency counter
become 3,000 Hz.
5. CHECKING THE MECHANISM TORQUES AND TENSION
• Clean the head, capstan and pinch roller before making any measurement.
Measurement Take-up torque Back tension Tape tension
Cassette for PLAY : TW-211A PLAY : TW-2111A Drive-power cassete
measurement F.FW/REW : TW-2231 TW-2412
PLAY 30 - 60 gr.cm 2.0 - 4.5 gr.cm 60 gr or more.
F.FWD 55 - 120 gr.cm. ----- -----
REW 55 - 120 gr.cm. ----- -----
1. HEAD REPLACEMENT
• After replacement, demagnetize the heads by using a degausser.
• Be sure to clean the heads before attempting to make any adjustments.
• All wiring should be returned to the original position after work is completed.
TAPE DECK ADJUSTMENTS
This is a basic adjustment.
3. AC BIAS FREQUENCY ADJUSTMENT
(1) Connect counter to T201(BS).
(2) R/P switch in recording state.
(3) Adjustment T801 a plastic screw , AC bias frequency : 80 kHz.
IC903 LA6541D(CD Driver)
1 2 3 4 5 6 7 8 9 10 11 12
13 14 15 16 17 18 19 20 21 22 23 24
Vcc Vref VIN4 VG4 Vo8 Vo7 GND Vo6 Vo5 VG3 VIN3 CD RES
Vcc Mute VIN1 VG1 Vo1 Vo2 GND Vo3 Vo4 VG2 VIN2 Reg OUT Reg IN
Vcc
11k 11k
11k 11k
Level
Sift
BTL
Driver
BTL
Driver
Level
Sift
RESET
Regulator
Level
Sift
BTL
Driver
Level
Sift
BTL
Driver
IC BLOCK DIAGRAM & DESCRIPTION