32
2 beeps are heard, then 2 beeps are heard again after 3 seconds,
and all settings return to the factory defaults. Then the UPS
returns to normal operation.
§
§
3
3
.
.
2
2
9
9
R
R
e
e
s
s
e
e
t
t
t
t
i
i
n
n
g
g
t
t
h
h
e
e
S
S
e
e
t
t
t
t
i
i
n
n
g
g
V
V
a
a
l
l
u
u
e
e
①
Check that the UPS is in the following condition.
②
Press and hold
for 3 or 4 seconds. Then release it when two beeps are heard.
③
Press
and hold this for at least 3 seconds once again. After 3 seconds, two beeps are heard, but keep
pressing this for 3 more seconds. Then release this when two beeps are heard again.
Resets the setting value to the factory
defaults. When you perform this operation,
all settings return to the factory defaults.
Menu items cannot be reset individually.
Changes to items marked with “RESTART” in the menu column of the menu list in §2 “Setup Menu
List” are reset after the UPS restarts. If you change any of these items, stop the UPS and start it
again. See §11.3 ”UPS Shutdown (If Not to Be Used for More Than a Week)” in the
E11A Instruction
Manual
for the shutdown procedure, and see §11.1 “UPS Startup” in the
E11A Instruction Manual
for the startup procedure. Always shut down connected loads before shutting the UPS down.
Note that the changes to items in §3.13 “Setting Battery Backup Time” and §3.14 “Setting Battery
Type” are not reset by the operations described above.
Note for changing Setting Values
MAIN SW on the back panel set to “ON” *1
The “Green INV.ON/STAND BY” and
the “Green OUTPUT are not blinking. *2
*1. Operation is possible regardless of whether
is ON or OFF.
*2. If these LEDs are blinking, Forced Bypass switch
may be set to “Bypass”. Set this switch to “Inverter”,
and restart the UPS.
Tip
The UPS switches to the user setting mode.
Buzzer sounds : 2 beeps
：
Either BATT.LOW or 25
blinks,
or both
BATT.LOW and 25
blink.
：
INPUT blinks.
：
LED is off.
：
LED is blinking.
Hold for 3 or 4 sec.
until 2 beeps.
Hold for 3 seconds or more.
