SANY SY50U, Руководство по эксплуатации и обслуживанию

Страница: 91 / 228

SY50U Excavator OMM Machine Operation
SANY
Operation and Maintenance Manual — 0120
4-7
TABLE OF
CONTENTS
INTRODUCTION
SAFETY
MACHINE
CONTROLS
MACHINE
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS
OPTIONAL
EQUIPMENT
Engine Oil Level Check
1. Prepare the machine for service. See “Maintenance
Safety” on page 2-8.
2. Open the engine hood. See “Opening the Engine Hood”
on page 5-21.
3. Remove the dipstick (1) and wipe off the engine oil
with a clean cloth.
4. Fully insert the dipstick into the dipstick opening, then
remove it and note the oil position on the dipstick.
5. The engine oil level must be maintained between the
upper mark (2) and lower mark (3) of the dipstick.
6. Add clean engine oil through the filler port (4) until the
oil level is at the upper mark of the dipstick. Always use
SANY-approved engine oil. See “Engine Oil Viscosity/
Temperature Data” on page
5-12.
NOTE: If the oil level is above the upper mark on the
dipstick, drain the excess oil. See “Change the
Engine Oil and Filter” on page
5-29
.
7. Install the dipstick.
WARNING!
Hot oil and engine components may cause burns or other serious injury. Allow the engine to
cool before performing engine maintenance. Failure to follow this warning could result in
death or serious injury.
NOTICE!
Do not add oil past the upper mark on the
dipstick, as this may result in engine damage.
Fig. 4-2
0002769
1
Fig. 4-3 0002770
2
3
Fig. 4-4
0002771
4