SANY SY155U, Руководство по эксплуатации и обслуживанию, Страница: 83 / 192

MACHINE OPERATION
4-15 SY155U Excavator OMM
Lower Front Windshield
0003628
Figure 4-27
1. Raise the windshield before removing the lower front
windshield. See “Opening the Windshield” on
page 4-13.
NOTE: Make sure the bottom of the lower front windshield
and the seal are clean. Accumulated dirt may
make the windshield difficult to remove or install.
2. Firmly hold the top of the lower front windshield (1)
and lift upward for removal.
NOTE: The lower front windshield is curved and will only
install as removed.
Cab Light
0003633
Figure 4-28
The cab light (1) is turned on and off by moving the
switch (2) up or down.
NOTE: The battery must be connected and the key switch
must be in the ON position for the cab light to
operate properly.
Mirrors
0003683
Figure 4-29
The machine has two mirrors (2) and one convex mirror
(3) for viewing around the machine.
To position the mirrors, loosen the mounting fasteners
(1). When positioned properly, tighten the mounting
fasteners securely.
NOTE:
The right mirror is shown. The left side is similar.
Check Fluid Levels
Complete the following procedures before starting the
engine:
• Engine Coolant Level – See “Check the Engine
Coolant Level” on page 5-14.
• Engine Oil Level – See “Check the Engine Oil Level”
on page 5-15.
• Fuel Level – See “Check the Fuel Level” on
page 5-16.
• DEF Level – See “Check the Diesel Exhaust Fluid
(DEF) Level” on page 5-16.
• Fuel Water Separator – See “Check the Primary
Fuel Filter/Water Separator” on page 5-17.
• Hydraulic Oil Level – See “Check the Hydraulic Oil
Level” on page 5-17.
• Windshield Washer Fluid – See “Check Windshield
Washer Fluid” on page 5-18.
1
2
1
3
2
1
1
1
1